NT 2640 Final Exam Answers (ITT Tech)
NT 2640 Final Exam Answers (ITT Tech)
This option correctly describes the port security feature found on Cisco switches.
a. Provides the capability to restrict the number of MAC addresses allowed to communicate through
b. SSID and MAC address
c. IP and MAC address
d. SSID and WEP key
When a switch receives an Ethernet frame to an unknown destination MAC address the switch applies the following logic:
a. IP and MAC address
b. SSID and WEP key
c. Floods the Ethernet frame out all interfaces except the received interface
d. SSID and MAC address
PPP protocol supporting binding many links into a single logical link in support of load balancing traffic across parallel links is referred to as
a. PPPoE
b. PPTP
c. a PPP Multilink
d. SLIP
Which of the following describes the collision domain design trade-offs?
a. Double frequency domain requires all devices on a segment to share the available bandwidth
b. Single collision domain requires all devices on a segment to share the available bandwidth
c. Single frequency domain requires all devices on a segment to share the available bandwidth
d. Double collision domain requires all devices on a segment to share the available bandwidth
Which part of IPv6 neighbor discovery replaces the capabilities of ARP?
a. Neighbor solicitation
b. Switchport mapper
c. Network mapper
d. Packet sniffer
Which one of the following is an encapsulation type of Frame Relay LMI?
a. ATM
b. ANSI
c. E1/T1
d. SCP
Which type of ICMP message will be returned to host by a remote router if that router does not have a route to network?
a. Connect all the switches to a battery backup.
b. Connect all the switches to a generator.
c. Destination the data centers power to a generator.
d. Destination Unreachable-Code Network unreachable
IPv6 broadcast addresses are used in similar manner to IPv4 broadcast addresses.
True or False
Which one of the following summary routes correctly includes the subnets 99.1.1.0, 99.1.2.0, and 99.1.3.0, mask 255.255.255.0 but does not include more prefexes than nessessary?
a. 98.1.3.0/22
b. 99.1.2.0/32
c. 99.1.1.0/22
d. 99.1.0.0/22
When a bridge/switch receives an Ethernet frame into a interface, what does it do with the source MAC address?
a. Records the MAC address and incoming port to create the MAC address/interface table entry
b. Enabling MAC address filtering on a switch
c. Add the MAC address to the host file.
d. Utilities shows the relationship between a MAC address and the
corresponding IP address
Which VTP mode configures the switch to receive and forward VTP messages but does not use the VTP messages to update the local VLAN database?
a. Port authentication
b. Trunking
c. Snips
d. Transparent
Which type of UTP cabling is required to connect to hosts back-to-back?
a. Cross-over
b. Roll-over
c. coaxial
d. fiber optic
Configuring route summarization is the same configuration steps for all routing protocols.
True or False
Which type of OSPF area router connects two areas?
a. NAT
b. DNS
c. Area border router (ABR)
d. SNMP
Which of the following is the MAC broadcast address for Ethernet?
a. FFFF.FFFF.FFFF.FFFF
b. FFFF.FFFF.FFFF
c. FFFF.FFFF.
d. FFF.FFF.FFF.FFF
When setting a local switchport to initiate the negotiation of a trunk link with the remote switch, the administrative mode is called ____.
a. Crossover
b. Rollover
c. Loopback
d. Dynamic desirable
_____ needs to match before two OSPF routers can form a neighbor relationship.
a. Interface ISAKMPD
b. Interface ARP
c. Interface SNORT
d. Interface MTU
Which of the following OSPF neighbor states is the expected state after completion of the exchange of topology information?
a. Mesh
b. Drop
c. Full
d. Bus
Which Cisco IOS show command aids in the troubleshooting of routing protocols by displaying information on which protocol(s) is enabled and as well as passive interfaces?
a. Release the IP Address
b. Show ip protocols
c. Install the IP protocol
d. Protocol show
Which IP header field is reduced by on on a router before attempting to forward the IP packet?
a. route
b. TTL or Time to live
c. traceroute
d. ping
When troubleshooting router IP connectivity, one of the first things to check is ____.
a. The interface status of all the interfaces to ensure Layer 1 & 2 connectivity has not failed
b. The interface status of all the interfaces to ensure Layer 3 & 2 connectivity has not failed
c. The interface status of all the interfaces to ensure Layer 4 & 6 connectivity has not failed
d. Commands can an administrator run to quickly locate connectivity
Inverse ARP in Frame Relay provides ____.
a. Commands can an administrator run to quickly locate connectivity
b. Mapping of the Layer 3 address and the layer 2 address
c. The interface status of all the interfaces to ensure Layer 1 & 2 connectivity has not failed
d. A particular route’s destination address
Which type of ICMP message will be returned to a host that is attempting to connect to a TCP port not utilized on a remote server?
a. Printing over a local network
b. Sniffing the network traffic
c. Sharing local network files
d. Destination Unreachable-Code Port unreachable
This term describes a type of network that is a non-broadcast network but allows more than two devices to be connected.
a. PPTP
b. VNC
c. NBMA
d. SSL VPN
The ____ algorithm is used by OSPF for calculating the best route to a destination.
a. IGP
b. Dijkstra
c. Latency
d. Next hop
_____ is an authentication type supported by PPP for end-point authentication.
a. CHAP
b. CSMA/CD
c. Token passing
d. CSMA/CA
OSPF is a ____ routing protocol.
a. Link-state
b. static
c. path-vector
d. Load balancer
The ____ type of ICMP message will be returned to a host using the “tracert” utility.
a. Ping
b. ARP utility
c. Netstat
d. Time Exceeded
Which of the following describes the forwarding logic followed by a switch when it receives a frame destined to a MAC address that is in its MAC address table?
a. Ensure the MAC address is correct
b. MAC filtering is enabled on the WAP
c. IP address to MAC address since both PCs have the same subnet mask and communication will occur.
d. Forward frame out interface specified in the MAC address table
The ____ switch frame processing model provides for verification of the FCS field.
a. Store-and-forward
b. Forwarding frames
c. Packet Forward
d. Hub-mesh-forward
When you apply the “passive interface serial0/1” command to the Cisco IOS OSPF configuration, the router will not send OSPF Hello packets out all interfaces.
True or False
_____ is the correct term for having simultaneous IPv4 and IPv6 networking enabled on a host or router.
a. Scheme
b. Gateways
c. Daul-stack
d. Bridges
_____ is used by OSPF as its metric.
a. Cost
b. RIP
c. BGP
d. Value
______ is the summary route that includes the subnets 192.168.129.0, 192.168.130.0, and 192.168.141.0, all with mask 255.255.255.0, but does not include more prefixes than necessary?
a. 192.168.0.0/24
b. 192.168.128.0/20
c. 172.30.0.0/32
d. 172.30.0.5/20
____ does not support VLSM.
a. RIP version 1
b. RIP version 2
c. BGP
d. OSPF
A _____ in a Frame Relay design uses subinterfaces.
a. Greater device security
b. Increased number of protocols can be used
c. A SOHO will be used in a small office environment
d. Partially meshed network with one IP subnet per PVC
_____ must match for two routers to form an EIGRP neighbor relationship.
a. Unmanaged switch
b. K values
c. DHCP server
d. Bridge
When adding a new IP subnet into an existing design that uses VLSM, care should be given to the process of validating that overlapping subnets do not exist.
True of False
____ are used in IPv6 to provide the ability for a host to learn the IP address of the next-hop router.
a. Unmanaged switch
b. Bridge
c. DHCP server route
d. Router Advertisements
The ____ IP header field is used to prevent an IP packet from existing on a network indefinitely.
a. SFTP
b. SNMPv3
c. FTP
d. TTL
The ____ best describes how a VLAN is mapped to an IP subnet.
a. Proxy server
b. Load balancer
c. Broadcast Domain
d. Bandwidth shaper
The _____ Cisco switch role correctly identifies the role of a switch that aggregates two lower levels of switches and is found in large campus environments.
a. Core
b. Show ip route
c. Ping
d. Case
Route summarization is_____.
a. Creating a summary route
b. Advertising a single prefix /IP network that includes all the more-specific routes, which reduces the number of routes in neighboring routers
c. Applying an inbound filter and configuring a passive interface
d. Applying an outbound filter to the shortest show ip route
____ is an open standard VLAN trunking protocol.
a. 802.1
b. 802.1Q
c. 806.1Q
d. 809.1D
An ICMP redirect is ______.
a. It allows each subnet in a routed system to be correctly sized for the requirement.
b. Every subnet must use a different mask to avoid conflicts.
c. Networks that use the same mask cannot route.
d. An ICMP message type used by routers to provide a mechanism to inform end hosts that a better path exists to the destination
A switchport configured as an “un-tagged” VLAN, uses the ____ switchport mode which is typically used for PCs.
a. Access
b. Trunk mode
c. Protect Port
d. Configuring Link Aggregation
Any routing protocol that supports VLSM must __________.
a. Multicast
b. Advertise IP subnet number and subnet mask information.
c. Automatically summarize networks to a common mask
d. Advertise the mask for each subnet in the routing update
CIR stands for _____.
a. Candid Information Rate
b. Comity Information Rate
c. Committed Information Rate
d. Careful Information Rate
A switch using Cut-Through fram processing allows the switch to discard frames that fail the FCS check.
True or False
When troubleshooting or configuring host IP connectivity, one of the first things to test is _____.
a. The ability to successfully ping your default gateway
b. The ability to see the server
c. The ability to register the MAC address
d. The ability to check the domain forest
APA Writing Checklist
Use this document as a checklist for each paper you will write throughout your GCU graduate program. Follow specific instructions indicated in the assignment and use this checklist to help ensure correct grammar and APA formatting. Refer to the APA resources available in the GCU Library and Student Success Center.
Check Out Also: HOSP 585: Week 8 Final Exam
☐ APA paper template (located in the Student Success Center/Writing Center) is utilized for the correct format of the paper. APA style is applied, and format is correct throughout.
☐ The title page is present. APA format is applied correctly. There are no errors.
☐ The introduction is present. APA format is applied correctly. There are no errors.
☐ Topic is well defined.
☐ Strong thesis statement is included in the introduction of the paper.
☐ The thesis statement is consistently threaded throughout the paper and included in the conclusion.
☐ Paragraph development: Each paragraph has an introductory statement, two or three sentences as the body of the paragraph, and a transition sentence to facilitate the flow of information. The sections of the main body are organized to reflect the main points of the author. APA format is applied correctly. There are no errors.
☐ All sources are cited. APA style and format are correctly applied and are free from error.
☐ Sources are completely and correctly documented on a References page, as appropriate to assignment and APA style, and format is free of error.
Scholarly Resources: Scholarly resources are written with a focus on a specific subject discipline and usually written by an expert in the same subject field. Scholarly resources are written for an academic audience.
Examples of Scholarly Resources include: Academic journals, books written by experts in a field, and formally published encyclopedias and dictionaries.
Peer-Reviewed Journals: Peer-reviewed journals are evaluated prior to publication by experts in the journal’s subject discipline. This process ensures that the articles published within the journal are academically rigorous and meet the required expectations of an article in that subject discipline.
Empirical Journal Article: This type of scholarly resource is a subset of scholarly articles that reports the original finding of an observational or experimental research study. Common aspects found within an empirical article include: literature review, methodology, results, and discussion.
Adapted from “Evaluating Resources: Defining Scholarly Resources,” located in Research Guides in the GCU Library.
☐ The writer is clearly in command of standard, written, academic English. Utilize writing resources such as Grammarly, LopesWrite report, and ThinkingStorm to check your writing.